The aerocar has a lightweight body structure
Posted: Thu Jan 30, 2025 9:49 am
When driving on the road in the folded state, the PAL-V Liberty is 4 m long, 2 m wide and 1.7 m high. The flying car is powered by a 100-horsepower aircraft engine. The maximum speed on the highway is 160 km/h, acceleration to 100 km/h takes 9 seconds. The stability of the tricycle is ensured by electronics, which tilt it when cornering.
For flight, the PAL-V Liberty adds another 100-horsepower engine, which is turned off on the road so as not to increase the already large CO2 emissions. The range is 400-500 km, and on the highway you can australia number data travel much more - 1,315 km.
The estimated cost of the flying car is 299 thousand euros. According to the manufacturers, the number of pre-submitted purchase applications has already exceeded all expectations.
Xpeng HT Aero air car
Chinese company XPeng, which specializes in developing electric vehicles, has unveiled a concept car called the HT Aero. The new product can drive on roads and take off into the air.
with aerodynamic shapes. In flight mode, special sliding elements with rotors at the ends extend from the sides, allowing the car to take off and land vertically.
Video player
For flight, the PAL-V Liberty adds another 100-horsepower engine, which is turned off on the road so as not to increase the already large CO2 emissions. The range is 400-500 km, and on the highway you can australia number data travel much more - 1,315 km.
The estimated cost of the flying car is 299 thousand euros. According to the manufacturers, the number of pre-submitted purchase applications has already exceeded all expectations.
Xpeng HT Aero air car
Chinese company XPeng, which specializes in developing electric vehicles, has unveiled a concept car called the HT Aero. The new product can drive on roads and take off into the air.
with aerodynamic shapes. In flight mode, special sliding elements with rotors at the ends extend from the sides, allowing the car to take off and land vertically.
Video player